A little preparation. A great finish.
Choose your size & fit your sticker
Measure your space, choose the right application and follow the guide for your product. Start here before you order or fit your decal.
01 / Find the right size
Make sure the design fits your space before placing your order.
Measure the usable space
Measure the width and height of the area where you want the sticker. Leave room around handles, seals, trims and the edge of the surface.
Mark it out with masking tape
Use small pieces of masking tape to mark the corners of the listed dimensions. Step back and check how the size looks in position before ordering.
Check the exact listing
Use the dimensions and sizing notes on your chosen product. For personalised text and multipacks, check whether the size refers to the lettering, each sticker or the complete design.
W means width. H means height. Product photographs show the design in use; use the listed measurements to judge the actual size.
02 / Inside or outside the glass?
When your chosen product offers an application option, select the side of the glass you want to fit it to.
Outside application
A normally cut design sticks to the outside face of the glass. The lettering reads correctly from outside.
Viewed from outside
Inside application
A mirrored design sticks to the inside face of the glass. It looks reversed from indoors and reads correctly through the glass from outside.
Viewed from outside
Both options are viewable from the outside.
Only choose inside application where it is offered on the product. If you are unsure which version to order, contact us before buying.
03 / Fit with confidence
Choose your product below for the full fitting instructions. Larger decals use hinge methods; peel-and-stick designs have their own guide.
Car & small transfer-tape stickers
For car, mirror, toilet, wall-tile and wine-glass stickers supplied with clear application tape.
Read the full guideCaravan & campervan decals
Includes edge-hinge and centre-hinge methods for larger designs.
Read the full guideShop window decals
For shop-window designs, including inside mirrored application.
Read the full guidePeel & stick wall art
For designs that peel directly from their backing paper.
Read the full guideSmall transfer-tape stickers: the essentials
This overview is for small stickers supplied with clear application tape. Follow the full guide above for your product before starting.
1. Clean & dry
Clean the surface with water only and dry it thoroughly. Do not use cleaning liquids, sprays or soap.
2. Prepare the tape
Lay the sticker flat. Rub or squeegee firmly over the clear tape so it holds the vinyl design.
3. Peel the backing
Slowly remove the backing paper, leaving the design on the clear tape. If a detail stays behind, lay it back down and rub it again.
4. Apply & smooth
Anchor one edge, then lower the sticker gradually while smoothing firmly with a squeegee or stiff card.
5. Fold the tape back
Peel the clear tape slowly back over itself at 180°. If the vinyl lifts, stop, press it down and squeegee again.
Finish by pressing down all edges and small details. Only the vinyl design remains on the surface.
04 / Need a hand?
The vinyl is lifting with the clear tape
Stop peeling. Lay the tape back down and squeegee firmly over that area. Continue slowly, folding the tape back over itself rather than pulling it towards you.
I can see bubbles or creases
Light air marks between the tape and backing paper on a rolled decal can occur in transit. If you have bubbles or creases after fitting, avoid lifting the whole design to try again. Send us a photo so we can help with your particular decal.
Can I reposition or reuse my sticker?
The stickers are single use. They can be removed, but cannot be repositioned or refitted after removal. Check the position carefully before applying.